| |
-
Southeastern Late model Sportsman Rules" & Toccoa
Speedway Limited Late model Rules
Frames:
A) Any jig or clip car
Roll Cage:
A. All cars have boxed roll cage with 1 1/2 o.d. x .083" min.
B. Must have 3 bars in left door and 2 bars in right door.
Bodies:
A) S.A.S, Lucas Oil
B) All non approved bodies will be assessed with a minimum of
50lb weight penalty
Wheels:
A) Aluminum or steal 14" max. Width.
B) NO! Carbon fiber
Tires:
1. Any Hoosier Spec or Crate Tire Permitted.
2. Cutting & Grooving Permitted
3. Any Hoosier Permitted on Right Rear..(Right Rear Only!!)
4. Any Open Tire Found at any other corner will mean automatic
disqualification.
5. No Extra Weight Required for cutting and Grooving!
Wheelbase:
A) 103 side to side 1” tolerance
Ignition:
A) No traction control
B) Any other is ok
Fuel:
A) Any racing fuel
B) No alcohol, No nitrous
Transmissions:
A) Bert and Brinn Transmissions allowed
B) Any type of clutch is permitted
C) Must have a forward and reverse. No direct drives
Carburetor:
A. One four barrel permitted. / NO dominators permitted.
Engine Placement:
A. Engine must not be more than 2" from center of the frame
rail.
B. Engine setback will be 6" from center of top ball joint to
most forward spark plug
Intake Manifold:
A. Aluminum intake permitted.
Engine
A. 362 cubic inches maximum.
B. Cast iron block only.
C Flat top pistons.
D. The dome may be removed from pop-up type pistons to make flat
top pistons
E. .060" overbore permitted.
F. High performance camshafts permitted.
G. No mushroom or roller lifters permitted.
H. Any steel rods permitted.
I. Crankshaft may be deburred.
J. 302 Fords may be stroked to meet 362 cubic inches.
L. Any wet oil pans permitted.
M. Lifter valley may be polished.
N. Balancing permitted.
O. Engine may be crossed from one manufacturer to another.
P. Crankshaft stock stroke.
Q. No dry sump permitted.
Heads:
A. Cast iron only. No C.C. limit
B. Matching of ports OK up to ½ in
C. H.P. valve springs and retainers permitted.
D. Titanium retainers permitted.
E. Needle bearing rocker arms permitted.
F. Maximum valve size: For all engines, Intake: 2,020, Exhaust:
1,600.
G. Chevy. 23 degree heads only. Angle cut heads permitted.
H. Screw in studs and guide plates permitted.
I. No more than 3 angles on valve jobs.
Weight Rule:
A. 2400 lbs After Race
B. 1lb. per lap burn off
C. Crate 602: 2200lbs
D. Crate 604: 2300lbs
Extra Engine Weights:
A. 10 degree Ford heads add 100 lbs
B. Polishing, porting heads add 50 lbs.
C. Intake porting, polishing add 50lbs
Protest!!!
There will be no Protest Allowed.
The Race Winner will be P & G after each event!
|
